How to use the Panic Button in i-Neighbour

i-Neighbour panic button is a feature attributed in the application which is designed to assist in sending immediate alert to someone during emergency situations at the premises. This panic button can be easily activated by holding the panic button icon to initiate the launching.

TimeTec BLE-2 is a device meant to be an intermediary between i-Neighbour guard panel and a barrier gate controller, intending to automate and monitor the opening of the barrier gate upon registration of a visitor through the i-Neighbour Visitor Management System using Bluetooth Low Energy (BLE) technology.

1. Hold the panic button icon for at least 3 seconds. Any holding that lasts shorter than 3 seconds will not trigger the panic button because this is a children preventive measure preconfigured in the system.
   
2. Once the owner has triggered the panic button, a pop-up panic page will appear as shown below.
• 2.1 Time frame to trigger the guard house
• 2.3 Switch to front camera
• 2.4 Allow siren on phone
• 2.5 Purpose of emergency
1. a) General
2. b) Robbery
3. c) Ambulance
4. d) Fire
• 2.6 Cancel panic alarm

Note: Cancel before the time frame runs out.

3. After the time has run out, i-Neighbour system will automatically snap 4 pictures from your back camera (by default).
4. The owner can cancel the photo from being uploaded by clicking on “Cancel Upload” (Optional)
   Note: The panic alert will still be synced to the guard house despite cancelling the uploaded photos.
   • 4.1 The countdown in seconds before successfully uploading the photos.
5. The photos are being uploaded.
6. To turn off the panic button, click on the siren icon.